Build one dormer box out on right hand side of house. 35’-40’ ladder set. 2-use almond sheet metal to cover hole on front of home where living space gutter meets garage roof.

Remove old lattice from deck in backyard. Install 1/4 stainless steel wiring to deck, dig 12 inches and apply concrete footer to protect property from wildlife. Paint lattice or stain lattice, color to be determined by customer

Repair both front and rear soffits to prevent entry by squirrels, raccoons, birds, bats or flying squirrels. Replace front louver vent with customer supplied louver vent and screen over vent with heavy gauge stainless steel screen to prevent animal entry as well.

30lf. Dig 2’ into ground around front porch structure. Create footer. Install quarter inch stainless steel into footer Pour concrete into footer over quarter inch stainless steel Attach stainless steel to bottom of front porch structure. Attach one-way door where active hole is Backfill area. Give allowed time come back remove …

Remove all of the batted/blown in insulation and mouse fecal matter. Sterifab the attire attic space to disinfect and treat for mites, lice, and bacteria. Install new baffles at the soffit lines and additional around the entry point. Install new batted insulation on the knee walls. Air seal gaps …

Remove current blown in/batt insulation as able (approximately 2000sqft) Sanitize attic space as able. Air seal accessible top plates, gaps and ceiling penetrations 1″ or less with sprayfoam Install new cellulose blown in insulation at recommended r-49 level. Build one box out in area indicated on grid.

Install stainless steel screen over vent. Sanitize vent, remove any debris in the vent.

Inside the attic space, spot clean the bat guano and sterifab the entire attic space to disinfect. Install a sheet metal along left side fire wall between the two homes to prevent crossover. On the exterior of the home, replace the screen on the louvre vent with a stainless steel …

Install up to 128 lf of critter guard on areas indicated on grid. Insulation In attic above living space (Approx 1530sqft) Remove existing insulation (combination of batt and blown in.) Sanitize area Air seal accessible top plates, gaps and ceiling penetrations 1″ or less with sprayfoam Install new cellulose blown in insulation …

Seal out around electric and cables lines going in home. Seal out all under front left, front right, back left corner. Seal out hole on corner of window on right side of home. Seal out around both sliding back doors. Seal out gas line entering home on back left corner. …

Seal out for squirrels, rodents, birds, bats, and raccoons. Using heavy gauge stainless steel screen and metal in a matching color, seal out entry points. Two louver vents to be covered with screen and Three areas; front left soffit, rear right soffit and gap at rake board trim on left …

Install new vent cover in attic vent opening, and caulk into place. Re caulk two other vent openings

Screen out exterior of two (2) louvre vents. Remove nesting and sanitize area in attic space Use sheet metal in area to custom create a seal out in area noted on grid. Approximately 3’ high and 4x 10.

White sheet metal on two eaves on frontside of home. Will require a 60 foot ladder to reach the areas of concern properly. Spot cleaning the squirrel feces in the attic space and use a Sterifab treatment to disinfect. Insulation levels are below the recommended levels. Blow in additional cellulose insulation …

Box out 4 corners of home with white sheet metal. (2 on front, 2 on left side) Install 3 white custom 45 degree slopes on top of pillars. Remove old exclusion work located in 2 spots in front of home and install white sheet metal to close off entry points. Run sheet metal to close up …