Installed heavy gauge stainless steel screen at underside of soffit, left rear of main roof, where it joins lower roof. Install heavy gauge stainless steel screen over the louver vent in garage attic. Inspect and repair screen out done previously on front soffit left side where it joins garage roof.

Install critter guard along gutter lines and secure any existing critter guard that was installed prior. Any screen that was installed on the sub roofing gap will be removed and the new critter guard installed. White sheet metal will be used for the critter guard.

Install 2 stainless steel RVGs on roof. Reconnect bathroom exhaust flex duct to interior roof. Reconnect duct to interior roof.

Clean small area in garage attic that is close to gable sanitize area as well.

Run screen metal approx 21’lf to cover deck gap. Sanitize area. This is to be done after removal of soffit, prior to replacement by deck company.

Install white sheet metal on seven eaves indicated by technician to prevent entry of squirrels into the attic space.

Install critter guard along the front and rear gutter lines to prevent entry of squirrels. Install stainless steel screen on ends of the ridge vent to prevent entry of squirrels.

Seal out all corners of home that are open. Seal out large bow in siding above back basement. Seal out right side of home where cable and phone lines enter. Seal out on left side of home 2 spots where A/C lines enter home.

Remove anything caught in trap. Install one (1) RVG. Stainless steel.

Install roof vent guard on the roof to prevent entry. Place large, baited sticky trap in attic for flying squirrels.

Reinstall the existing soffit back in place as best as possible. Install cream colored sheet metal over indicated soffit corner to prevent entry of squirrels into the attic space. Install same colored sheet metal on one eave on backside of home indicated by the technician. Remove section of soiled insulation …

Up to 30’ critter guard. Sanitize attic space impacted by squirrels.

Install 28 ft of animal barrier under deck, attach 1/4 stainless steel wire to deck and bury 18 inches with concrete at bottom to prevent any other wildlife from living under deck. Install hatch over crawl space 16/24 inches. Remove all batted insulation and old plastic from crawl space. Close off all old crawl …

Install a white sheet metal over the fascia board to prevent entry of squirrels. Reinstall both gutters with hidden hangers. Include wrapping the return (corner of the rake board) with white sheet metal. Install Evelyn’s white 5 inch leaf solutions on front gutter only and cap the ends to prevent …

Seal out using caulk and copper mesh, seal up gap behind trim board front of home outside Nicole’s bedroom. Seal and repair gap on right side of home near side entry. Clean Out And Screen Vent. A bath vent on the side of the home has a large wasp …