Seal underneath freeze board over brick garage or left-hand side of home, seal freeze board on front left side of home attached to brick at gable, seal freeze board along the front side of home that attaches to brick. Almond color will be used to seal openings and prevent any …

Install metal (sandstone beige) on six eaves on the front of the home to prevent entry of squirrels into the attic space. Wrap a section of frieze board near the main entry point indicated by the technician.

Soffit ajar on main part of roof where roof meets soffit on both sides. 32′ ladder. Place white sheet metal in soffit area to strengthen places where soffit is ajar. 2-3 places. Screen over vent that leads into garage birds are getting in.

Exclusion on both sides of gutter with almond color metal to cover fascia area impacted by squirrels. Sanitize 2×2 area in front of entrance points. Remove impacted blown in insulation and replace with access from other areas in attic.

Install stainless steel chimney cap.

Remove all insulation from each joist box in the basement and seal with caulk and insulating foam, seal up any mice entry holes with copper mesh, or solid metal and weather/moisture seal with caulk, then replace insulation with new fiberglass batts. Clean up any debris. Remove hardened and shrunk …

Birds in fireplace to be frightened off and we will remove all nesting materials possible. Interior area of chimney to be disinfected. Nesting materials to be bagged and removed. Chimney cap to be installed on top of flue.

Remove insulation from attic to include road and droppings, two treatments to be conducted within a month prior to attic being cleaned out. Install r 38 batted insulation to current standard over cathedral ceiling on 1/2 of attic and blow in r38 cellulose insulation on the other half. Attic to be disinfected …

Install reinforced critter guard on front rear of home behind gutters to secure with screws to prevent flying squirrels from chewing through corners of wood behind gutters. Seal underneath with almond color sealant at rake board or left hand side of home over front porch and on the left side …

Replace rake board at rear of home left side and then wrap with almond color metal Reinstall siding on the rear roof left side under rake that’s being replaced that has calmed attached by wind, reinforce with screws. Install ridge guard on top of roof or front and rear …

3 louver vents with stainless steel, seal gaps with caulk at top of bricks, clean small area of attic.

Bat Seal Out and One Way Seal up as much a roof area at chimney as possible, allowing bat exit through a one-way exit. Return remove one way and seal completely.

Install heavy gauge stainless steel screen over louver vents to prevent entry, caulk 20” long gap at vent. Remove insulation where bats have left guano and sanitize a ten square foot area and replace insulation there with loose cellulose.

Create an animal barrier using heavy gauge stainless steel screen buried to a depth of 20 inches and embedded in a concrete curb. The screen will be permanently affixed to the sides of the shed. 36 linear feet, Consisting of the front and side but not the rear of the shed.

Trim back shrubs as needed around deck on rear of home, dig down approximately 10 inches and pour concrete and install stainless screen barrier wall around perimeter of deck and pin it to underneath of deck. Existing lattice work will have to be polled and reinstalled after work is complete, corners …