Install quarter inch stainless steel screen on four gable vents to prevent entry of bats. Use clear caulk and copper cloth on the gaps between the rake board and the brick, frieze board (front and back) and the brick, and the rear left siding piece where it touches the brick. …

Extensive rodent infestation in attic. Snake skins noted as well. Batted insulation is worn out and damaged. Customer complaint of front guest BR has insulation spitting out of ceiling register and snakes have been an issue for some time around the property. Demo all batted insulation in attic. Perform air …

Re install the existing soffit line on the front of the home to prevent entry of bats into the attic space. Install stainless steel screen around the furnace cap on the roof.

Install heavy gauge stainless steel screen over whole house fan vent, and four louver vents. (2 on each side of home) to prevent bats, squirrels, flying squirrels or raccoons from entry. Caulk water spigot left side of home, copper mesh three conduits to seal them from rodent entry.

Seal up entry points under soffit with metal. Two soffits behind gutters above the screened porch. One soffit on upper roof at eave. Install heavy gauge stainless steel screen over round louver vent to prevent animal or bat entry. Cover small gaps above front entry at soffit to prevent wasp …

Cover 3 vents with 1/4 stainless to help prevent wildlife from entering home. Install new galvanized RVG over attic fan on roof of home.

Cover 4 gable vents with 1/4 inch stainless steel screen from the outside. Remove dead bird in vent on right side of home and sanitize. Apply custom white sheet metal to 2 areas as indicated by technician.

Set 2 “one ways” on either side of the chimney. Run for up to 14 days. Seal areas with off white sheet metal at the end of the one way portion. Sanitize area.

Cover 2 gable vents from exterior with 1/4 inch stainless steel to prevent wildlife from entering attic. Set 32 foot ladder up against chimney in rear of home. Open up damaged siding on chimney, remove debris, sterilize and install temporary patch.

Add 5 inches of blown in cellulose insulation giving the customer an R-value close to 49. Remove old 3 inch uninsulated flex from bath fan. Install new 3 inch insulated flex.

Remove all old blown in insulation from attic. Clean up all feces and sanitize heavily due to wildlife activity. Air seal all cracks with blown in cellulose insulation. Install new baffles around attic entrance and rafters. Apply 13 inches of blown in cellulose insulation giving the customer an R- value of 49. …

Remove all batted and blown in insulation in the attic space. Include removal of the raccoon feces. Steirfab the entire attic space to disinfect. Air seal gaps and conduit lines for energy efficiency. Install new baffles at the soffit lines and around the entry point. Install new batted insulation on …

Two separate attics with evidence of widespread squirrel and mouse activity. Insulation is held from occupied spaces by reinforced liner and that liner is damaged/down in places. Demo all batted insulation from both spaces. Sanitize both attic spaces with multi-quat sanitizer.Install new reinforced 12 mil liner on bottom chord …

Dig down to a depth of up to 24 inches around front porch and portion of sidewalk. Attach 1/4 inch stainless steel screen to edge concrete, pour foot at base of trench. A 1-way will be install on construction date, and removed a few days later. After 1-way is removed the remaining …

Repair the ripped area of shingles and plywood with a permanent patch Using heavy gauge stainless steel screens seal up the soffit and the chimney from animal entry